Canon imagePRESS Server A2200 - Page 124

TROUBLESHOOTING 124
Startup (cont.)
Control Panel screen and
Activity light appear as
follows:
Problem with the Windows
operating system.
1. Recheck all cables and connections.
2. Reboot the imagePRESS Server.
3. If the problem persists, reinstall system software
(see page 105).
Activity light status
progresses from solid green
to solid red.
Possibly one of the following:
• Problem with system software
• Print job is corrupt or too large
• Faulty UIB cable
• CPU overheated
• Faulty motherboard
1. If you suspect that the problem may be caused by a print
job, try printing a different job.
2. Recheck all cables and connections.
3. Reboot the imagePRESS Server and check whether the CPU
cooling assembly fan is operating. If the fan is properly
connected to the motherboard but does not operate, replace
the cooling assembly.
4. If the problem persists, reinstall system software
(see page 105).
5. If the problem persists, try connecting another UIB cable
(see Figure 14 on page 49).
6. If the problem persists, replace the motherboard (see
page 65).
FieryBar messages
Check copier power &
Video cable connections
appears on the optional
monitor, if present.
Possibly one of the following:
• Problem with the connection
between the imagePRESS Server and the
copier
• The copier is not powered on
• The copier is on but is not ready
to print
1. Make sure that the copier is powered on and ready to print.
2. Make sure that the copier interface cable is the correct type
and is correctly connected to both the copier and the
imagePRESS Server.
3. If the problem persists:
• Recycle power on the copier.
• Recycle power on the imagePRESS Server by shutting down
through the imagePRESS Server Control Panel, waiting 10
seconds, and then powering the imagePRESS Server back
on (see page 42).
4. If the problem persists, replace the copier interface cable
(see page 112).
5. If the problem persists, replace the copier interface board
(see page 57).
6. If the problem persists, you may need to service
the copier.
Symptom Possible cause Suggested action
STARTING UP...
Activity light status:
Blinking green,
then solid red.
Activity light status:
Solid green, then
solid red.