Canworld CDE360-2S0R7 - Page 151

CDE360 Vector Control AC Drive Chapter 6 Parameters Description
C4.02
Range: -100.0~100.0
Default: 0.0
Corresponding
setting of FI
minimum input
Unit: %
The percent of corresponding to pulse minimum input frequency.
C4.03
Range: C4.01~100.00
Default: 50.00
FI maximum
input
Unit: kHz
If the pulse input higher C4.03 then it will be limited by C4.03.
C4.04
Range: -100.0~100.0
Default: 100.0
Corresponding
setting of FI
maximum input
Unit: %
The percent of corresponding to pulse maximum input frequency.
C4.05
Range: 0.00~10.00
Default: 0.10
FO filter time
Unit: Sec
If the parameter of C4.05 is non-zero then the pulse output function is
enabled. Increase the value of this parameter to stabilize pulse output.
C4.06
Range: 0~17
Default: 1
FO function
When C1.00 set to 0, the pulse output function is enabled, the functions
description please see the parameter description of C3.02.
C4.07
Range: 0.00~100.00
Default: 0.00
FO output
minimum
frequency
Unit: kHz
Set the minimum pulse output pulse.
C4.08
Range: 0.0~C4.10
Default: 0.0
Corresponding
setting of FO
output minimum
frequency
Unit: %
The percent of corresponding to pulse minimum output frequency.
C4.09
FO output maximum
frequency
Range: 0.00~100.00
Default: 50.00
Unit: kHz
Set the maximum pulse output pulse.
C4.10
Range: C4.08~100.0
Default: 100.0
Corresponding
setting of FO output
maximum frequency
Unit: %
The percent of corresponding to pulse maximum output frequency.