Canworld CDE360-2S0R7 - P1 Debug Parameters; P2 Factory Parameters

CDE360 Vector Control AC Drive Chapter 5 Parameter List Table
-85-
P0.13
User-defined Parameter 13
A0.00～P1.15 【A0.14】
P0.14
User-defined Parameter 14
A0.00～P1.15 【A0.15】
P0.00 ~P0.14 default value is different. When P0.00 ~P0.03 default value is special for H0.05 =
3, it is fitting for PID application.
P0.15
User-defined Parameter 15
H0.05～H0.05 【H0.05】
P0.15 can not be revised.
P1 Debug Parameters
Function
Code
Name
Range
Default
Step
Description
P1.00~
P1.15
Debug parameter i
(i=0,1,2,3,......,15)
0~65535
0
1
Reserved for factory debug, user don't
change them unless receive guidance
from factory engineers suggestions.
P2 Factory Parameters
Function
Code
Name
Range
Default
Step
Description
P2.00
Factory password
0~9999
0
1
Remark：CDE360 series without AO2 output and X5 input