Canworld CDE360-2S0R7 - Page 86

CDE360 Vector Control AC Drive Chapter 5 Parameter List Table
-73-
Function
Code
Name
Range
Default
Step
Description
E5.25
Cut-off frequency of PID
reverse rotation
0.00~b0.00
0.00
0.01Hz
E5.26
PID deviation limit
0.0~100.0
0.00
0.1%
Base on PID setting value
E5.27
PID deviation limit delay time
0.0~320.0
0.0
0.1Sec
E5.28
PID integral property
00~11
00
1
Unit's digit (Integral separated) 0: Inactive 1: Active
Ten's digit (Whether to stop integral operation when the output reaches the limit)
0: Continue integral operation
1: Stop integral operation
E5.29
PID operation at stop
0~1
1
1
0: No PID operation at stop
1: PID operation at stop
E5.30
PID feedback detection enable
0~1
0
1
0: Disabled
1: Enabled
E5.31
Minimum frequency of PID
feedback detection
0.00~b0.00
5.00
0.01Hz
E5.32
Waiting time of PID feedback
detection
0.0~600.0
0.0
0.1Sec
E5.33
Upper limit of PID feedback detection
E5.03~E5.02
100.0
0.1%
Unit/Decimal depends
on E5.00/E5.01.
E5.34
Lower limit of PID feedback detection
E5.03~E5.02
0.0
0.1%
E5.35
Detection time of PID
feedback detection
0.0~600.0
0.0
0.1Sec
E5.36
wake up level
0.0~200.0
0.0
0.1
Unit/Range
depends on E5.44.
E5.37
wake up delay time
0.0~6500.0
0.0
0.1Sec
E5.38
Sleep mode
0~1
0
1
0: Based on output frequency
1: Based on PID feedback
E5.39
Sleep level
0.0~200
0.0
0.1
Unit/Range
depends on E5.44.
E5.40
Sleep frequency
0.00~b0.00
0.00
0.01Hz
E5.41
Sleep delay time
0.0~6500.0
0.0
0.1Sec
0 means no sleep
function.
E5.42
PID setting high limit
0.0~100.0
100.0
0.1%
PID setting value limit
of internal operation.
E5.43
PID setting low limit
0.0~100.0
0.0
0.1%
E5.44
①
Base value selection of PID
sleep and wake up threshold
0~1
0
1
The Unit/Range of E5.36 and E5.39 is determined by E5.44.
0:Unit is Percentage (%),base value is PID setting and range is 0.0~200.0%.
1:Unit is the same as PID engineering unit(E5.04),range is E5.03~E5.02.