Cellwatch Frontier System Installation & User Manual
Section I – Installation Guide-14
Installation Safety
The following safety precautions should be observed before any work is performed on the
system containing the NDSL product.
This system is intended for installation by personnel who are trained and qualified to
recognize the hazards associated working with such systems and are familiar with the safety
precautions required to avoid possible injury.
Never work on any system that threatens life
or injury through hazardous voltages. Even
when safety precautions have been taken.
NEVER WORK ALONE. Always ensure that
two properly trained personnel are on site.
NDSL recommends that when performing
any work concerned with batteries, that the
safety procedures and safe working practices
as described in the appropriate battery
manufacturers documentation should be
followed at all times.
Never make unauthorized changes or
modifications to equipment. This may create
unsafe or even hazardous situations.
Where the battery documentation
recommends that links are removed for safe
working, it is important to totally remove any
Cellwatch unit which is connected across
any link to be broken prior to separation and
subsequent removal of the link. FAILURE
TO DO SO WILL RESULT IN THE STRING
NOT BEING TOTALLY ISOLATED.
After servicing of the battery, any removed links must be fitted and reconnected before the
Cellwatch
™
modules are reconnected.
Safety glasses should be worn at all times.
Ensure all equipment and tools are safe and in good working order.
Ensure electrical tools have been tested for proper insulation and grounding.
Do not wear loose clothing, jewelry, long hair when working near rotating machinery.
Appropriate PPE should be utilized depending upon the application and hazards present.
Observe all CAUTIONS, WARNINGS and DANGER notices on equipment, tools, and
buildings whether internally or externally displayed.
To Next Page
Loading...