CS35 2013.04
3.1.13-63 3.1.13-63Electronic Control System - ME7
3. Inspect the AC compressors and the electrical fans close
A. Turn the ignition switch to position "LOCK".
B. Disconnect the A/C compressor solenoid clutch.
C. Whether the A/C system inspecting is normal.
D. Restore the solenoid clutch connector.
Is the system normal after disconnecting the sole-
noid clutch and fan wiring harness connector?
Y
Repair the fault of solenoid clutch doesn’t switch off.
N
Go to step 4.
4. Inspect the trouble code
A. Connect the diagnostic tool.
B. Turn the ignition switch to position "ON", diagnose
the engine system.
Is there any fault?
Y
Go to trouble code diagnosis procedure.
Refer to: DTC Diagnostic Procedure Index
(3.1.13 Electrical Control System - ME7,
DTC Diagnosis and Testing).
N
Go to step 5.
5. Inspect the spark plug
A. Remove the spark plug.
B. Inspect the spark plug in each cylinder and whether
the model and clearance meet the standard,
Refer to: Spark Plug Test (3.1.8 Ignition
System, General Procedures).
Is the spark plug in each cylinder normal?
Y
Go to step 6.
N
Replace the spark plug.
Test Conditions Details/Results/Actions
mashinesoft.com
09120146259