Chroma 62000P Series - 4.3 Program Execution

Program Sequence
4.2.8 Setting Time
1. Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-9 (8)
shows.
2. Use the numeric (
0
~
1
) keys or “Rotary” ( ) knob to set the value.
This function is to set the time sustained when Sequence reaches CV Mode or CC Mode.
This setting TIME = only appears when SEQ. TYPE = AUTO.
3. Press “
ENTER
” to confirm.
4. Press “
EXIT
” to return to Program PAGE (Figure 4-1).
4.3 Program Execution
When the sequences are finished for editing, press “
OUTPUT
” to start execution and press
“
EXIT
” to abort it.
4.3.1 Executing a Program
1. Press “
OUTPUT
” will prompt a confirmation page as Figure 4-15 shows.
P
R
O G
R
A M
R
UN ?
P
R
E S S [ O U T P U T ] T O E X C U T E
Figure 4-15
2. Press “
OUTPUT
” again to confirm the execution and go to MAIN PAGE as Figure 4-16
shows. To quit the execution, press “
EXIT
” will return to Program page or Sequence
page.
4-15