Programmable DC Power Supply 62000P Series Operating & Programming Manual
CONFIG PAGE
1. SYSTEM SETUP
GPIB ADDR
RS-232 BAUDRATE
APG
BACKLIGHT
TTL VALUE
BUZZER
I LIMIT
V SLEW RATE
TTL VALUE
3.SERIES/
PARALLEL
PARALLEL OR SERIES
MASTER & SLAVE CONTROL
NUM. OF SLAVE
7.CALIBRATION
VOLTAGE [PROG./MEAS.]
CURRENT [ PROG./MEAS.]
APG VOLTAGE
[PROG./MEAS.]
APG CURRENT [PROG./MEAS.]
4.DISPLAY
NONE,V/I LIMIT , V/I/P PROTECT,
V/I SLEWRATE, TTL VALUE
6.FACTORY
SETTING
V LIMIT
NUMBER OR SLAVE
POWER ON STATUS
5. PROTECTION
2. OUTPUT SETUP
OVP
OCP
OPP
FOLDBACK
I SLEW RATE
RECALL DEFAULT
READING AVERAGE TIMES
Figure 3-4
3.3.1 SYSTEM SETUP
1. In Config setup page, press “
1
” will display the screen of Figure 3-5.
3-4
To Next Page
Loading...
