Programmable DC Power Supply 62000P Series Operating & Programming Manual
LCD front panel. For internal cleaning, use a low-pressure air gun the dust inside or send it
back to our agent for cleaning.
2.2 Preparation for Use
(1) Be sure the Power Supply is connected to the AC line input that meets the specification.
(2) The instrument must be installed in an air-circulated area to avoid the internal
temperature getting too high.
(3) The ambient temperature does not exceed 40°C.
2.2.1 Normal Environment Conditions
(1) In door use.
(2) Altitude up to 2000m.
(3) Temperature 5°C to 40°C.
(4) Maximun relative humidity 80% for temperature up 31°C decreasing linearity to 50%
relative humidity at 40°C
(5) Input AC supply voltage fluctuations can up to +-10% of the rated voltage.
(6) Tansient overvoltage is impulse withstand CAT II
(7) Pollution degree II
2.3 Requirements of Input Power
2.3.1 Ratings
Input Voltage Range : 95 ~ 250 Vac, single phase
Input Frequency : 47~ 63 Hz
Max. Current/Max. Power : 18A/1700VA
CAUTION
If the input voltage is not within the range as described above, the output will shut down
automatically to protect the DC Power Supply.
2.3.2 Input Connection
(1) The input connector board is located at the right of rear panel.
(2) The power line must be 85°C rated at least.
(3) The power cable width must be within 10AWG~12AWG.
(4) To assemble it ¨ see Figure 2-2 and execute the following steps:
a. Remove the input terminal safety cover from the rear panel of DC Power Supply.
b. Scrape off the skin of power cable tip (the bare portion is about 1cm) and tin it.
c. Insert the power terminal and secure it with a Phillips screwdriver.
d. Lock the safety cover to avoid electric shock.
2-2
To Next Page
Loading...
Need help?
General
