Installation
2. Installation
2.1 Checking the Package
(1) Check if there is any damage or any missing accessories after unpacking it.
(2) Should any damage it found, contact “Chroma RMA” immediately to request return
shipment.
The machine package is shown as below.
Figure 2-1
NOTICE
1. Please keep all of the packing materials in case the device has to be returned for repair.
2. Do not return the instrument to the factory without obtaining prior RMA acceptance from
Chroma.
2.1.1 Maintenance & Cleaning
Remove all connected wires and cables on the instrument before cleaning. Use a brush to
clean the dust on it and if there are stains on the chassis that cannot be removed by brush,
wipe it with volatile liquid (such as Cleaning Naphtha). Do not use any corrosive liquid to
avoid damaging the chassis. Use a damp cloth with soap water or soft detergent to clean the
2-1
To Next Page
Loading...
Need help?
General
