Chroma 62000P Series - Setting PROG CHAIN no

Program Sequence
2. Use the numeric (
0
~
9
) keys or “Rotary” ( ) knob to set the value.
3. Press “
ENTER
” to confirm.
4. Press “
EXIT
” to return to MAIN PAGE.
[PR
O
G
R
A M ]
P
R
O G N O . = 1
P
R
O G C H
A
IN N O . = 0
R
U N C
O
U N T = 0
C L E A
R
S E Q . = N O
▼
)1(
)2(
)3(
)4(
Figure 4-3
Since there are 10 programs for setting, the PROG NO. range is 1 ~ 10.
4.1.1.2 Setting PROG CHAIN NO.
1. Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-3 (2)
shows.
2. Use the numeric (
0
~
9
) keys or “Rotary” ( ) knob to set the value.
The PROGRAM CHAIN NO. means the link among programs. It is required when
executing different programs.
The setting range is 0 ~ 10.
(1) Set PROG CHAIN NO. to 0
When setting PROG CHAIN NO. = 0, it means no program link.
(2) Set PROG CHAIN NO. to non 0
When setting PROG CHAIN NO. to non-0, it means to perform program link as the
example listed below.
Ex.1: Link execution among programs
Set PROG #1 to PROG CHAIN NO.=3, RUN COUNT=1
PROG #3 to PROG CHAIN NO.=4, RUN COUNT=1
PROG #4 to PROG CHAIN NO.=6, RUN COUNT=1
PROG #6 to PROG CHAIN NO.=0, RUN COUNT=1
The program execution flow is listed as Figure 4-4 shows.
4-3