Manual Operation
[ S E R I E S / P A R A L L E L ]
M A S T E R & S L A V E C O N T R O L =
YES
M A S T E R O R S L A V E = M A S T E R
P A R A L L E L O R S E R I E S = P A R A L L E L
N U M . O F S L A V E = 1
Figure 3-29
NOTICE
1. For 62000P Series to be operated in series/parallel mode, it is necessary to set SLAVE
first and MASTER last, or it will show communication error and unable to work.
2. If the setting procedure is reversed by setting the MASTER (MASTER OR SLAVE =
MASTER) first, when pressing “
EXIT
” to return to MAIN PAGE, the MASTER’s
MAIN PAGE will show as below.
_ S E T = 8 0 . 0 0 V I _ S E T = 1 5 . 0 0
M
S
O F F
0 0 . 0 0
00 . 00A
0 .
W
E
S . E
Figure 3-30
Setting Method:
1. Use “
”, “
” keys to move the cursor to the column to be set.
2. Use the numeric (
0
~
1
) keys or “Rotary” (
) knob to set the DC Power Supply to
MASTER or SLAVE. See the description in section 3.3.3.3.1 if MASTER is selected
and see section 3.3.3.3.4 if SLAVE is selected.
3. Press “
ENTER
” to confirm.
4. Press “
EXIT
” to return to MAIN PAGE.
3-21
To Next Page
Loading...
Need help?
General
