What to do if focus is slightly wrong on Chronos 1.4?
If the focus is slightly wrong on your Chronos Digital Camera, and proper focus is out of range, it could be due to a mis-adjusted back-focus. Re-adjust the back-focus. Also, the Computar 12.5-75mm lens, among others, is slightly soft at fully wide aperture. Close aperture slightly and retry. Try f/2 or smaller.
What to do if Chronos 1.4 Digital Camera battery won't charge?
If the battery of your Chronos Digital Camera isn't charging, try these steps: First, unplug the AC adapter from the camera and then plug it back in. Also, double-check that the AC adapter is providing the correct voltage, which should be between 17 and 20V DC with a positive tip.
Why is the power status indicator flashing red/green continuously on my Chronos 1.4 Digital Camera?
If the power status indicator on your Chronos Digital Camera is continuously flashing red and green, it could indicate that the power controller is in recovery mode. Try turning the camera off, then removing the battery and disconnecting the AC adapter for 10 seconds. When reconnecting the power or inserting the battery, make sure you are not pressing the power button until after the LED flashing stops.
Why does the battery indicator drop very fast on my Chronos 1.4?
If the battery indicator on your Chronos Digital Camera is dropping very quickly, it likely means you have a low-quality or failing battery. The suggested solution is to replace the battery.
How to fix slightly wrong focus on Chronos 1.4?
If the focus on your Chronos Digital Camera is slightly off, and proper focus seems out of range, it could be due to a misadjusted backfocus. Try readjusting the backfocus. It may also be due to the lens limitation. Some lenses are slightly soft at fully wide aperture. Close aperture slightly and retry. Try f/2 or smaller.
How to solve focus problems while zooming Chronos Digital Camera?
If your Chronos Digital Camera lens doesn’t maintain consistent focus while zooming, it could be due to a mis-adjusted back-focus. Re-adjust the back-focus. Also, some lenses, especially lower-end lenses, do not maintain focus during zoom, so focus needs to be adjusted after zooming.
Why Chronos 1.4 battery won’t charge?
If the battery in your Chronos Digital Camera isn’t charging, it could be due to a couple of reasons. If the battery was inserted after the AC adapter was connected, unplug the AC adapter from the camera and then re-plug it. Also, ensure that the AC adapter is providing between 17V and 20V DC with a positive tip.
What to do if the power status indicator flashes red/green continuously on Chronos 1.4?
If the power status indicator on your Chronos Digital Camera flashes red/green continuously, it indicates that the power controller is in recovery mode. Turn the camera off, remove the battery, and disconnect the AC adapter for 10 seconds. When reconnecting the power or inserting the battery, make sure the power button is not pressed until after the LED flashing stops. If the issue persists, it might indicate a power controller firmware corruption.
What to do if battery indicator drops very fast on Chronos 1.4 Digital Camera?
If the battery indicator on your Chronos Digital Camera drops very quickly, it is likely due to a low quality or failing battery. The suggested solution is to replace the battery.
Why is a negative ghost image visible on my Chronos 1.4 Digital Camera?
If you're seeing a negative ghost image over the normal image on your Chronos Digital Camera, it's likely because the black cal was done without the lens cap on or with the aperture open. Perform the black cal again, ensuring you close the aperture fully or cover the lens.
Introduces the Chronos camera and guides users through the manual's structure and purpose.
Provides essential contact details, website links, and user forum for customer support and technical assistance.
Details on unpacking the camera and listing all standard included accessories.
Overview of the camera's physical layout, buttons, screen, and ports.
Guides through disabling shipping mode, lens installation, and powering on the camera.
Instructions for powering the camera down and charging the battery.
Covers setting resolution, frame rate, performing black calibration, and white balance.
Explains recording modes, ring buffer concept, and live recording.
Details on using triggers, I/O settings, and synchronizing the camera.
How to review captured footage and save it to storage.
Setting up network connectivity and accessing the camera via web control.
Detailed explanation of camera software menus, controls, and specific functions.
Covers hardware overview, lens compatibility, technical specifications, maintenance, and troubleshooting.
General| Sensor Type | CMOS |
|---|---|
| Resolution | 1280x1024 |
| Storage | SD card |
| Display | 5" LCD |
| Battery | Li-ion |
| Connectivity | USB, HDMI, Ethernet |
| Memory | 8GB |
To Next Page
