Contents
xxix
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Configuring an MPLS TE Tunnel 34-21
Configuring the Routing Protocol for MPLS TE 34-22
Configuring TE Fast Reroute 34-22
Configuring a Protected Link to Use a Backup Tunnel 34-24
Configuring Fast Reroute Failure Detection (Optional) 34-24
Configuring Primary and Backup Autotunnels 34-25
Understanding EoMPLS 34-26
Interaction with Other Features 34-27
EoMPLS and IEEE 802.1Q Tunneling 34-27
EoMPLS and Layer 2 Tunneling 34-28
EoMPLS and Q in Q 34-29
EoMPLS and QoS 34-30
EoMPLS Limitations 34-30
Enabling EoMPLS 34-30
Default EoMPLS Configuration 34-31
EoMPLS Configuration Guidelines 34-31
Configuring EoMPLS 34-31
Configuring the Pseudowire Using Pseudowire Class 34-33
Configuring L2VPN Interworking 34-34
EoMPLS and EVC 34-35
Packet Flow in an EoMPLS Network 34-36
Configuring L2VPN Pseudowire Redundancy 34-37
Configuration Guidelines 34-38
Configuring Pseudowire Redundancy 34-39
Forcing a Manual Switchover to the Backup Pseudowire VC 34-40
Monitoring L2VPN Pseudowire Redundancy 34-40
Support for H-VPLS 34-41
Understanding MPLS OAM 34-42
LSP Ping 34-43
LSP Traceroute 34-44
AToM VCCV (LSP Ping over Pseudowire) 34-44
IP SLAs Interworking with MPLS OAM 34-44
LSP Tree Trace and IP SLAs ECMP Tree Trace 34-45
Configuring MPLS OAM and IP SLAs MPLS 34-45
Default MPLS OAM Configuration 34-45
MPLS OAM Configuration Guidelines 34-46
Using LSP Ping for LDP IPv4 FEC 34-46
Using LSP Traceroute for LDP IPv4 FEC 34-48
Using LSP Ping for Pseudowire (AToM VCCV) 34-49
To Next Page
Loading...
