36-3
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 36 Configuring Online Diagnostics
Running Online Diagnostic Tests
Switch(config)# end
Switch# show diagnostic schedule
Current Time = 10:21:24 UTC Thu Dec 4 2008
Diagnostic:
Schedule #1:
To be run on December 4 2008 10:22
Test ID(s) to be executed: 1.
At the scheduled time, the switch runs the test:
Switch# #
Dec 4 10:21:59.492: %DIAG-6-SCHED_RUNNING: : Performing Scheduled Online Diagnostic...
Dec 4 10:21:59.492: %DIAG-6-TEST_RUNNING: : Running TestPortAsicStackPortLoopback{ID=1} ..
Dec 4 10:22:00.498: %DIAG-6-TEST_OK: : TestPortAsicStackPortLoopback{ID=1} has completed
successfully
Dec 4 10:22:00.498: %DIAG-6-SCHED_COMPLETE: : Scheduled Online Diagnostic is completed
For more examples, see the “Examples” section for the diagnostic schedule test command in the
command reference for this release.
Running Online Diagnostic Tests
After you configure online diagnostics, you can manually start diagnostic tests or display the test results.
You can also see the tests configured for the switch and the tests that have already run.
• Starting Online Diagnostic Tests, page 36-3
• Displaying Online Diagnostic Tests and Results, page 36-4
Starting Online Diagnostic Tests
After you configure diagnostic tests to run on the switch, use the diagnostic start privileged EXEC
command to begin diagnostic testing.
Note After starting the tests, you cannot stop the testing process.
To Next Page
Loading...
Need help?
General