Cisco 3845 - Security Bundle Router Software Guide

29-65
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 29 Configuring IP Unicast Routing
Configuring ISO CLNS Routing
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config-router)# exit
Router B
Switch(config)# clns routing
Switch(config)# router isis
Switch(config-router)# net 49.0001.0000.0000.000b.00
Switch(config-router)# exit
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config-router)# exit
Router C
Switch(config)# clns routing
Switch(config)# router isis
Switch(config-router)# net 49.0001.0000.0000.000c.00
Switch(config-router)# exit
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# ip router isis
Switch(config-if)# clns router isis
Switch(config-router)# exit
Configuring IS-IS Global Parameters
• You can force a default route into an IS-IS routing domain by configuring a default route controlled
by a route map. You can also specify other filtering options configurable under a route map.
• You can configure the router to ignore IS-IS LSPs that are received with internal checksum errors
or to purge corrupted LSPs, which causes the initiator of the LSP to regenerate it.
• You can assign passwords to areas and domains.
• You can create aggregate addresses that are represented in the routing table by a summary address
(route-summarization). Routes learned from other routing protocols can also be summarized. The
metric used to advertise the summary is the smallest metric of all the specific routes.
• You can set an overload bit.
• You can configure the LSP refresh interval and the maximum time that an LSP can remain in the
router database without a refresh
• You can set the throttling timers for LSP generation, shortest path first computation, and partial
route computation.
• You can configure the switch to generate a log message when an IS-IS adjacency changes state (up
or down).
• If a link in the network has a maximum transmission unit (MTU) size of less than 1500 bytes, you
can lower the LSP MTU so that routing will still occur.

Cisco 3845 - Security Bundle Router Specifications

General

Brand	Cisco
Model	3845 - Security Bundle Router
Category	Switch
Language	English