EasyManua.ls Logo

Cisco 3845 - Security Bundle Router

Cisco 3845 - Security Bundle Router
956 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32-33
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 32 Configuring Ethernet OAM, CFM, and E-LMI
Configuring E-LMI
OAM manager, which streamlines interaction between any two OAM protocols, handles the interaction
between CFM and E-LMI. This interaction is unidirectional, running only from OAM manager to E-LMI
on the UPE side of the switch. Information is exchanged either as a result of a request from E-LMI or
triggered by OAM when it received notification of a change from the OAM protocol. This type of
information is relayed:
Remote UNI name and status
Remote UNI counts
The ME 3800X and ME 3600X switch can be only a customer-edge device.
Configuring E-LMI
Most E-LMI configuration occurs on the PE switch on the interfaces connected to the CE device. On the
CE switch, you only need to enable E-LMI on the connecting interface.
The switch supports only E-LMI-CE configuration.
Default E-LMI Configuration, page 32-33
E-LMI Configuration Guidelines, page 32-33
Enabling E-LMI, page 32-34
Enabling Ethernet OAM, page 32-36
Ethernet OAM and CFM Configuration Example, page 32-36
Default E-LMI Configuration
Ethernet LMI is globally disabled by default.
When you globally enable E-LMI by entering the ethernet lmi global global configuration command,
it is automatically enabled on all interfaces. You can also enable or disable E-LMI per interface to
override the global configuration. The E-LMI command that is given last is the command that has
precedence.
There are no UNIs defined. UNI bundling service is bundling with multiplexing.
E-LMI Configuration Guidelines
The switch supports E-LMI only for the customer edge. The provider side of the connection must be
running CFM and E-LMI.
E-LMI is not supported on routed ports, EtherChannel port channels or ports that belong to an
EtherChannel.
You cannot configure E-LMI on VLAN interfaces.
You must enter the ethernet lmi ce global configuration command to enable the switch or interface
in customer-edge mode.

Table of Contents

Other manuals for Cisco 3845 - Security Bundle Router

Related product manuals