Cisco 3845 - Security Bundle Router Software Guide

20-3
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 20 Configuring CDP
Configuring CDP
Use the no form of the CDP commands to return to the default settings.
This example shows how to configure CDP characteristics.
Switch# configure terminal
Switch(config)# cdp timer 50
Switch(config)# cdp holdtime 120
Switch(config)# cdp advertise-v2
Switch(config)# end
For additional CDP show commands, see the “Monitoring and Maintaining CDP” section on page 20-5.
Disabling and Enabling CDP
CDP is enabled by default.
Note Cisco devices (such as Cisco IP Phones) regularly exchange CDP messages with connected devices.
Disabling CDP can interrupt device connectivity.
Beginning in privileged EXEC mode, follow these steps to globally disable the CDP device discovery
capability:
Beginning in privileged EXEC mode, follow these steps to globally enable CDP when it has been
disabled:
This example shows how to globally enable CDP if it has been disabled.
Switch# configure terminal
Switch(config)# cdp run
Switch(config)# end
Step 6
show cdp Verify your settings.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no cdp run Disable CDP.
Step 3
end Return to privileged EXEC mode.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cdp run Enable CDP after disabling it.
Step 3
end Return to privileged EXEC mode.

Cisco 3845 - Security Bundle Router Specifications

General

Brand	Cisco
Model	3845 - Security Bundle Router
Category	Switch
Language	English