Cisco 3845 - Security Bundle Router

22-4
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 22 Configuring UDLD
Configuring UDLD
Default UDLD Configuration
Table 22-1 shows the default UDLD configuration.
Configuration Guidelines
• A UDLD-capable port cannot detect a unidirectional link if it is connected to a UDLD-incapable
port of another switch.
• When configuring the mode (normal or aggressive), make sure that the same mode is configured on
both sides of the link.
Caution Loop guard works only on point-to-point links. We recommend that each end of the link has a directly
connected device that is running STP.
Table 22-1 Default UDLD Configuration
Feature Default Setting
UDLD global enable state Globally disabled
UDLD per-port enable state for fiber-optic media Disabled on all Ethernet fiber-optic ports
UDLD per-port enable state for twisted-pair (copper) media Disabled on all Ethernet 10/100 and 1000BASE-TX ports
UDLD aggressive mode Disabled