Cisco 3845 - Security Bundle Router Software Guide

25-13
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 25 Configuring SNMP
Configuring SNMP
Note Many commands use the word traps in the command syntax. Unless there is an option in the command
to select either traps or informs, the keyword traps refers to traps, informs, or both. Use the snmp-server
host global configuration command to specify whether to send SNMP notifications as traps or informs.
Table 25-5 describes the supported switch traps (notification types). You can enable any or all of these
traps and configure a trap manager to receive them.
Table 25-5 Switch Notification Types
Notification Type Keyword Description
alarms Generates alarm traps.
auth-framework Generates SNMP CISCO-AUTH-FRAMEWORK-MIB traps.
bgp Generates Border Gateway Protocol (BGP) state change traps.
bridge Generates STP bridge MIB traps.
config Generates a trap for SNMP configuration changes.
config-copy Generates a trap for SNMP configuration copy changes.
copy-config Generates a trap for SNMP copy configuration changes.
cpu threshold Generates a trap for CPU threshold violations.
config Generates a trap for SNMP configuration changes.
eigrp Generates a trap for SNMP EIGRP changes.
envmon Generates environmental monitor traps. You can enable any or all of these environmental
traps: fan, shutdown, status, supply, temperature.
ethernet-cfm Generates an SNMP Ethernet CFM trap.
flash Generates SNMP FLASH notifications.
hsrp Generates a trap for Hot Standby Router Protocol (HSRP) changes.
ipmulticast Generates a trap for IP multicast routing changes.
mac-notification Generates a trap for MAC address notifications.
mpls-fast-reroute Generates a trap for MPLS traffic engineering fast reroutes.
mpls-ldp Generates a trap for MPLS label distribution protocol changes.
mpls-traffic-eng Generates a trap for MPLS traffic engineering changes.
mpls-vpn Generates a trap for MPLS Virtual Private Network (VPN) changes.
msdp Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
ospf Generates a trap for Open Shortest Path First (OSPF) changes. You can enable any or all of
these traps: Cisco specific, errors, link-state advertisement, rate limit, retransmit, and state
changes.
pim Generates a trap for Protocol-Independent Multicast (PIM) changes. You can enable any or
all of these traps: invalid PIM messages, neighbor changes, and rendezvous point
(RP)-mapping changes.
rtr Generates a trap for the SNMP Response Time Reporter (RTR).
snmp Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link
up or link down.

Cisco 3845 - Security Bundle Router Specifications

General

Brand	Cisco
Model	3845 - Security Bundle Router
Category	Switch
Language	English