Cisco 3845 - Security Bundle Router

27-36
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 27 Configuring QoS
Configuring QoS
Step 5
conform-action {drop |
set-cos-transmit cos_value |
set-discard-class
discard_value |
set-dscp-transmit dscp_value |
set-mpls-exp-imposition-tran
smit new-exp |
set-mpls-exp-topmost-transm
it
new-exp | set-prec-transmit
value | set-qos-transmit
value |
transmit}
(Optional) Enter the action to be taken on packets that conform to the CIR.
• drop—drop the packet.
• set-cos-transmit cos_value—set the CoS value to a new value, and send the
packet. The range is 0 to 7.
• set-discard-class-transmit discard_value—set the discard value to a new
value, and send the packet. The range is 0 to 7.
• set-dscp-transmit dscp_value—set the IP DSCP value to a new value, and
send the packet. The range is 0 to 63. You also can enter a mnemonic name for
a commonly used value or use the question mark (?) to see a list of available
values.
• set-mpls-exp-imposition-transmit new-exp—enter the new MPLS
experimental value to be set at tag imposition, and send the packet. The range
is 0 to 7.
• set-mpls-exp-topmost-transmit new-exp—enter the new MPLS experimental
value for the outermost or topmost label, and send the packet. The range is 0
to 7.
• set-prec-transmit value—set the IP precedence value to a new value, and send
the packet. The range is 0 to 7.
• set-qos-transmit value—set the QoS group number to a new value, and send
the packet. The range is 0 to 99.
• transmit—send the packet without altering it. This is the default.
Note If you are configuring a single action for conformed and exceeded packets,
you can specify them in the same line. If configuring multiple actions, press
ENTER after the conform-action command.
Command Purpose