Cisco 3845 - Security Bundle Router

32-9
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
Chapter 32 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
Step 12
continuity-check loss-threshold threshold-value (Optional) Set the number of continuity check messages to
be missed before declaring that an MEP is down. The range
is 2 to 255; the default is 3.
Step 13
maximum meps value (Optional) Configure the maximum number of MEPs
allowed across the network. The range is from 1 to 65535.
The default is 100.
Step 14
sender-id {chassis | none} (Optional) Include the sender ID TLVs, attributes
containing type, length, and values for neighbor devices.
• chassis—Send the chassis ID (host name).
• none—Do not include information in the sender ID.
Step 15
mip auto-create [lower-mep-only | none] (Optional) Configure auto creation of MIPs for the service.
• lower-mep-only—Create a MIP only if there is a MEP
for the service in another domain at the next lower
active level.
• none —No MIP auto-create.
Step 16
exit Return to ethernet-cfm configuration mode.
Step 17
mip auto-create [lower-mep-only] (Optional) Configure auto creation of MIPs for the domain.
• lower-mep-only—Create a MIP only if there is a MEP
for the service in another domain at the next lower
active level.
Step 18
mep archive-hold-time minutes (Optional) Set the number of minutes that data from a
missing maintenance end point is kept before it is purged.
The range is 1 to 65535; the default is 100 minutes.
Step 19
exit Return to global configuration mode.
Step 20
interface interface-id Specify an interface to configure, and enter interface
configuration mode.
Step 21
switchport mode trunk (Optional) Configure the port as a trunk port.
Step 22
ethernet cfm mip level level-id (Optional) Configure a customer level or service-provider
level maintenance intermediate point (MIP) for the
interface. The MIP level range is 0 to 7.
Note This step is not required if you have entered the
ethernet cfm mip auto-create global
configuration command or the mip auto-create
ethernet-cfm or ethernet-cfm-srv configuration
mode.
Command Purpose