Index
IN-10
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
authentication 29-38
components 29-34
configuring 29-36
default configuration 29-35
definition 29-33
interface parameters, configuring 29-37
monitoring 29-40
stub routing 29-39
support for 1-8
ELIN location 21-3
E-LMI
CE device configuration 32-35
configuration guidelines 32-33
configuring a CE device 32-34
default configuration 32-33
defined 32-32
enabling 32-34
information 32-33
monitoring 32-35
enable password 8-3
enable secret password 8-3
encapsulation, in pseudowire redundancy 34-33
encapsulation on service instances 11-4
encapsulation types supported 11-5
encryption for passwords 8-3
Enhanced IGRP
See EIGRP
environment variables, function of 3-21
EoMPLS
and 802.1Q tunneling 34-27
and Layer 2 protocol tunneling 34-28
and QoS 27-13, 34-30
configuring 34-31
default configuration 34-31
limitations 34-30
monitoring 34-60
packet flow 34-36
equal cost multipath tree trace
See ECMP tree trace
equal-cost routing 1-8, 29-94
error messages during command entry 2-4
EtherChannel
802.3ad, described 28-5
automatic creation of 28-4, 28-5
channel groups
binding physical and logical interfaces 28-3
numbering of 28-3
configuration guidelines 28-9
configuring
Layer 2 interfaces 28-10
Layer 3 physical interfaces 28-13
Layer 3 port-channel logical interfaces 28-12
default configuration 28-9
described 28-1
displaying status 28-20
forwarding methods 28-6, 28-15
interaction
with STP 28-9
with VLANs 28-10
LACP
described 28-5
displaying status 28-20
hot-standby ports 28-17
interaction with other features 28-6
modes 28-5
port priority 28-18
system priority 28-18
Layer 3 interface 29-2
load balancing 28-6, 28-15
logical interfaces, described 28-3
PAgP
aggregate-port learners 28-16
compatibility with Catalyst 1900 28-16
described 28-4
displaying status 28-20
interaction with other features 28-5
learn method and priority configuration 28-16
modes 28-4
To Next Page
Loading...
