Index
IN-19
Cisco ME 3800X and 3600X Switch Software Configuration Guide
OL-23400-01
See EtherChannel
Link Failure, detecting unidirectional 14-7
link integrity, verifying with REP 16-3
Link Layer Discovery Protocol
See CDP
link monitoring, Ethernet OAM 32-23, 32-26
link redundancy
See Flex Links
links, unidirectional 22-1
link state advertisements (LSAs) 29-29
LLDP
configuring 21-3
characteristics 21-3
default configuration 21-3
disabling and enabling
globally 21-4
on an interface 21-5
monitoring and maintaining 21-7
overview 21-1
supported TLVs 21-2
transmission timer and holdtime, setting 21-3
LLDP-MED
configuring 21-3
configuring TLVs 21-6
monitoring and maintaining 21-7
overview 21-1, 21-2
supported TLVs 21-2
LLDP Media Endpoint Discovery
See LLDP-MED
load balancing 30-4
location TLV 21-2, 21-6
logging messages, ACL 26-8
login authentication
with RADIUS 8-22
with TACACS+ 8-14
login banners 5-17
log messages
See system message logging
loop guard
described 15-4
enabling 15-9
support for 1-5
LSP Health Monitor
configuring 34-51
described 34-50
LSP multipath tree trace 34-45
LSP ping
configuring 34-46
described 34-43
over pseudowire
configuring 34-49
described 34-44
LSP traceroute
configuring 34-48
described 34-44
LSP tree trace
defined 34-56
manually configuring 34-56
LSR 34-3
M
MAC addresses
aging time 5-21
and VLAN association 5-20
building the address table 5-20
default configuration 5-21
disabling learning 5-29
discovering 5-30
displaying 5-29
dynamic
learning 5-20
removing 5-21
in ACLs 26-26
IP address association 29-7
static
adding 5-27
allowing 5-28, 5-29