Procedure
Step 1
Push the screwdrivers into the left and right holes in the phone mounting plate approximately 1 in. (2.5 cm).
Step 2
Lift the screwdriver handles up to push down on the tabs.
Figure 28: Disengage Tabs
Step 3
Press firmly to disengage the tabs and move the phone up at the same time to release the phone from the wall
bracket.
Adjust the Handset Rest
If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need to adjust the
handset rest to ensure that the receiver does not slip out of the cradle.
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
90
Adjust the Handset Rest
To Next Page
Loading...
