Cisco 7906G Administration Guide

7-5
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Status Menu
Ta b l e 7-2 Status Messages on the Cisco Unified IP Phone 7906G and 7911G
Message Description Possible Explanation and Action
BootP server used The phone obtained its IP
address from a BootP server
rather than from a DHCP
server.
None. This message is informational only.
CFG file not found The name-based and default
configuration file was not
found on the TFTP Server.
The configuration file for a phone is created
when the phone is added to the Cisco Unified
CallManager database. If the phone has not
been added to the Cisco Unified CallManager
database, the TFTP server generates a
CFG
File Not
Found response.
• Phone is not registered with Cisco
Unified CallManager.
You must manually add the phone to
Cisco Unified CallManager if you are not
allowing phones to auto-register. See the
“Adding Phones with
Cisco Unified CallManager
Administration” section on page 2-15 for
details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses, check
configuration of the TFTP server. See the
=
“Network Configuration Menu” section
on page 4-7for details about assigning a
TFTP server.
CFG TFTP Size Error The configuration file is too
large for file system on the
phone.
Power cycle the phone.

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English