Cisco 7906G Administration Guide

2-17
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
Converting a New Phone from SCCP to SIP
A new, unused phone is set for SCCP by default. To convert this phone to SIP,
perform these steps:
Procedure
Step 1 Take one of these actions:
• To auto-register the phone, set the Auto Registration Phone Protocol
parameter in Cisco
Unified CallManager Administration to SIP.
• To provision the phone using the Bulk Administration Tool (BAT), choose the
appropriate phone model and choose SIP from the BAT.
• To provision the phone manually, make the appropriate changes for SIP on
the Phone Configuration page in Cisco
Unified CallManager Administration.
Refer to Cisco Unified CallManager Administration Guide for more information
about Cisco
Unified CallManager configuration. Refer to
Cisco
Unified CallManager Bulk Administration Guide for more information
about using the BAT.
Step 2 If you are not using DHCP in your network, configure the network parameters for
the phone.
See the “Configuring Startup Network Settings” section on page 3-14.
Step 3 Power cycle the phone.
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from
Cisco
Unified CallManager Administration, choose Bulk Administration >
Phones > Migrate Phones > SCCP to SIP. For more information, refer to the
“Migrating Phones” chapter in the Cisco
Unified CallManager Bulk
Administration Guide.

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English