Cisco 7906G Administration Guide

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
2-16
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Adding Phones with BAT
The Cisco Bulk Administration Tool (BAT) is a plug-in application for
Cisco
Unified CallManager that enables you to perform batch operations,
including registration, on multiple phones.
Before you can add phones using BAT only (not in conjunction with TAPS), you
must obtain the MAC address for each phone.
For information about determining a MAC address, see the “Determining the
MAC Address of a Cisco Unified IP Phone” section on page 2-19.
For detailed instructions about using BAT, refer to the
Cisco
Unified CallManager Administration Guide and to the
Cisco
Unified CallManager Bulk Administration Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-13
• Adding Phones with Auto-Registration and TAPS, page 2-14
• Adding Phones with Cisco Unified CallManager Administration, page 2-15
Using Cisco Unified IP Phones with Different
Protocols
The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control
Protocol) or SIP (Session Initiation Protocol). You can convert a phone that is
using one protocol for use with the other protocol.
This section includes these topics:
• Converting a New Phone from SCCP to SIP, page 2-17
• Converting an In-Use Phone from SCCP to SIP, page 2-17
• Converting an In-Use Phone from SIP to SCCP, page 2-18
• Deploying a Phone in an SCCP and SIP Environment, page 2-18

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English