Cisco 7906G Administration Guide

2-15
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified CallManager Database
Auto-registration must be enabled in Cisco Unified CallManager Administration
(System
> Cisco CallManager) for TAPS to function.
Note Cisco Unified CallManager automatically disables auto-registration if you
configure the cluster-wide security mode for authentication and encryption
through the Cisco CTL client.
Refer to the Cisco Unified CallManager Bulk Administration Guide for detailed
instructions about BAT and about TAPS.
Related Topics
• Adding Phones with Auto-Registration, page 2-13
• Adding Phones with Cisco Unified CallManager Administration, page 2-15
• Adding Phones with BAT, page 2-16
Adding Phones with Cisco Unified CallManager Administration
You can add phones individually to the Cisco Unified CallManager database
using Cisco
Unified CallManager Administration. To do so, you first need to
obtain the MAC address for each phone.
For information about determining a MAC address, see the “Determining the
MAC Address of a Cisco Unified IP Phone” section on page 2-19.
After you have collected MAC addresses, choose Device > Add a New Device in
Cisco
Unified CallManager Administration to begin.
For complete instructions and conceptual information about
Cisco
Unified CallManager, refer to Cisco Unified CallManager Administration
Guide and to Cisco
Unified CallManager Bulk Administration Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-13
• Adding Phones with Auto-Registration and TAPS, page 2-14
• Adding Phones with BAT, page 2-16

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English