Cisco 7906G Administration Guide

Chapter 1 An Overview of the Cisco Unified IP Phone
Understanding the Requirements for Configuring and Installing Cisco Unified IP Phones
1-30
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
4. Configure these network settings on
the phone by choosing Settings >
Network Configuration.
Note Unlock the phone settings
before making these changes
from the phone.
To enable DHCP:
a. Set DHCP Enabled to Yes .
b. To use an alternate TFTP
server, set Alternate TFTP
Server to Ye s . Enter IP
address for TFTP Server 1.
To disable DHCP:
a. Set DHCP Enabled to No.
b. Enter static IP address for
phone.
c. Enter subnet mask.
d. Enter default router IP
addresses.
e. Enter domain name where
phone resides.
f. Set Alternate TFTP Server to
Ye s . Enter IP address for
TFTP Server 1.
Using DHCP—The IP
address is automatically
assigned and the
Cisco
Unified IP Phone is
directed to a TFTP Server.
Note Consult with the
network
administrator if you
need to assign an
alternative TFTP
server instead of
using the TFTP
server assigned by
DHCP.
Without DHCP—You must
configure the IP address,
TFTP server, subnet mask,
domain name, and default
router locally on the phone.
See the “Configuring Startup
Network Settings” section on
page 3-16.
See the “Network
Configuration Menu” section on
page 4-7.
5. Set up security on the phone. Provides protection against
data tampering threats and
identity theft of phones.
See the “Configuring Security
on the Cisco Unified IP Phone”
section on page 3-17.
6. Make calls with the
Cisco
Unified IP Phone.
Verifies that the phone and
features work correctly.
Refer to the
Cisco
Unified IP Phone 7906G
and 7911G Guide.
Table 1-5 Checklist for Installing the Cisco Unified IP Phone 7906G and 7911G Series in
Cisco Unified CallManager (continued)
Task Purpose For More Information

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English