Cisco ASA Series User Manual

1-19
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Management Access
Configuring AAA for System Administrators
Prerequisites for Management Accounting
• Configure CLI authentication (see the “Configuring Authentication for CLI and ASDM Access”
section on page 1-20).
• Configure enable authentication (see the “Configuring Authentication to Access Privileged EXEC
Mode (the enable Command)” section on page 1-20).
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
IPv6 Guidelines
Supports IPv6.
Default Settings
Default Command Privilege Levels
By default, the following commands are assigned to privilege level 0. All other commands are assigned
to privilege level 15.
• show checksum
• show curpriv
• enable
• help
• show history
• login
• logout
• pager
• show pager
• clear pager
• quit
• show version
If you move any configure mode commands to a lower level than 15, be sure to move the configure
command to that level as well, otherwise, the user will not be able to enter configuration mode.
To view all privilege levels, see the “Viewing Local Command Privilege Levels” section on page 1-28.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model