EasyManuals Logo

Cisco ASA Series User Manual

Cisco ASA Series
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #148 background imageLoading...
Page #148 background image
1-12
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the Transparent or Routed Firewall
Customizing the MAC Address Table for the Transparent Firewall
Customizing the MAC Address Table for the Transparent
Firewall
This section describes how you can customize the MAC address table and includes the following
sections:
Adding a Static MAC Address, page 1-12
Setting the MAC Address Timeout, page 1-12
Disabling MAC Address Learning, page 1-13
Adding a Static MAC Address
Normally, MAC addresses are added to the MAC address table dynamically as traffic from a particular
MAC address enters an interface. You can add static MAC addresses to the MAC address table if desired.
One benefit to adding static entries is to guard against MAC spoofing. If a client with the same
MAC address as a static entry attempts to send traffic to an interface that does not match the static entry,
then the ASA drops the traffic and generates a system message. When you add a static ARP entry (see
the Adding a Static ARP Entry” section on page 1-10), a static MAC address entry is automatically
added to the MAC address table.
To add a static MAC address to the MAC address table, enter the following command:
Setting the MAC Address Timeout
The default timeout value for dynamic MAC address table entries is 5 minutes, but you can change the
timeout. To change the timeout, enter the following command:
Command Purpose
mac-address-table static interface_name
mac_address
Example:
hostname(config)# mac-address-table static
inside 0009.7cbe.2100
Adds a static MAC address entry.
The interface_name is the source interface.
Command Purpose
mac-address-table aging-time timeout_value
Example:
hostname(config)# mac-address-table
aging-time 10
Sets the MAC address entry timeout.
The timeout_value (in minutes) is between 5 and 720 (12 hours). 5 minutes
is the default.

Table of Contents

Other manuals for Cisco ASA Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA Series and is the answer not in the manual?

Cisco ASA Series Specifications

General IconGeneral
ModelASA 5505
InterfacesVaries by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High AvailabilityActive/Standby or Active/Active (varies by model)
Power SupplyVaries by model
Form FactorVaries by model
Operating SystemCisco ASA Software
IPsec VPNSupported
SSL VPNSupported
IPS ThroughputVaries by model

Related product manuals