Cisco ASA Series User Manual

1-25
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA IPS Module
Monitoring the ASA IPS module
Monitoring the ASA IPS module
To check the status of a module, enter one of the following commands:
Examples
The following is sample output from the show module details command, which provides additional
information for an ASA with an SSC installed:
hostname# show module 1 details
Getting details from the Service Module, please wait...
ASA 5500 Series Security Services Card-5
Hardware version: 0.1
Serial Number: JAB11370240
Firmware version: 1.0(14)3
Software version: 6.2(1)E2
MAC Address Range: 001d.45c2.e832 to 001d.45c2.e832
App. Name: IPS
App. Status: Up
App. Status Desc: Not Applicable
App. Version: 6.2(1)E2
Data plane Status: Up
Status: Up
Mgmt IP Addr: 209.165.201.29
Mgmt Network Mask: 255.255.224.0
Mgmt Gateway: 209.165.201.30
Mgmt Access List: 209.165.201.31/32
209.165.202.158/32
209.165.200.254/24
Mgmt Vlan: 20
The following is sample output from the show module ips command for an ASA 5525-X with an IPS
SSP software module installed:
hostname# show module ips
Mod Card Type Model Serial No.
--- -------------------------------------------- -----------------------------
ips IPS 5525 Intrusion Protection System IPS5525 FCH1504V03P
Mod MAC Address Range Hw Version Fw Version Sw Version
--- --------------------------------- ------------ ---------------------------
ips 503d.e59c.6f89 to 503d.e59c.6f89 N/A N/A 7.1(1.160)E4
Mod SSM Application Name Status SSM Application Version
--- ------------------------------ ------------------------------------------
ips IPS Up 7.1(1.160)E4
Mod Status Data Plane Status Compatibility
--- ------------------ --------------------- -------------
ips Up Up
Command Purpose
show module
Displays the status.
show module {1 | ips} details
Displays additional status information. Specify 1 for a physical module
and ips for a software module.
show module {1 | ips} recover
Displays the network parameters for transferring an image to the module.
Specify 1 for a physical module and ips for a software module.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model