EasyManuals Logo

Cisco ASA Series User Manual

Cisco ASA Series
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1752 background imageLoading...
Page #1752 background image
1-8
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Remote Access IPsec VPNs
Configuring Remote Access IPsec VPNs
Detailed Steps
Configuring ISAKMP Policy and Enabling ISAKMP on the Outside
Interface
This section describes the procedure to configure an ISAKMP policy on the outside interface and how
to enable the policy.
Detailed Steps
Perform the following commands:
Command Purpose
Step 1
interface {interface}
Example:
hostname(config)# interface ethernet0
hostname(config-if)#
Enters interface configuration mode from global configuration
mode.
Step 2
ip address ip_address [mask] [standby
ip_address]
Example:
hostname(config)# interface ethernet0
hostname(config-if)#
hostname(config-if)# ip address
10.10.4.200 255.255.0.0
Sets the IP address and subnet mask for the interface.
Step 3
nameif name
Example:
hostname(config-if)# nameif outside
hostname(config-if)#
Specifies a name for the interface (maximum of 48 characters).
You cannot change this name after you set it.
Step 4
shutdown
Example:
hostname(config-if)# no shutdown
hostname(config-if)#
Enables the interface. By default, interfaces are disabled.

Table of Contents

Other manuals for Cisco ASA Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA Series and is the answer not in the manual?

Cisco ASA Series Specifications

General IconGeneral
ModelASA 5505
InterfacesVaries by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High AvailabilityActive/Standby or Active/Active (varies by model)
Power SupplyVaries by model
Form FactorVaries by model
Operating SystemCisco ASA Software
IPsec VPNSupported
SSL VPNSupported
IPS ThroughputVaries by model

Related product manuals