EasyManuals Logo

Cisco ASA Series User Manual

Cisco ASA Series
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #668 background imageLoading...
Page #668 background image
1-36
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring OSPF
Configuring OSPFv3
Sending Syslog Messages
To configure the router to send a syslog message when an OSPFv3 neighbor goes up or down, perform
the following steps:
Detailed Steps
Suppressing Syslog Messages
To suppress the sending of syslog messages when the route receives unsupported LSA Type 6 multicast
OSPF (MOSPF) packets, perform the following steps:
Detailed Steps
Command Purpose
Step 1
ipv6 router ospf process-id
Example:
hostname(config-if)# ipv6 router ospf 1
Enables an OSPFv3 routing process and enters IPv6 router
configuration mode.
The process-id argument is an internally used identifier for this
routing process, is locally assigned, and can be any positive
integer from 1 to 65535. This ID does not have to match the ID on
any other device; it is for internal administrative use only. You can
use a maximum of two processes.
Step 2
log-adjacency-changes [detail]
Example:
hostname(config-rtr)#
log-adjacency-changes detail
Configures the router to send a syslog message when an OSPFv3
neighbor goes up or down.
The detail keyword sends a syslog message for each state, not
only when an OSPFv3 neighbor goes up or down.
Command Purpose
Step 1
router ospf process_id
Example:
hostname(config-if)# router ospf 1
Enables an OSPFv2 routing process and enters router
configuration mode.
The process_id argument is an internally used identifier for this
routing process, is locally assigned, and can be any positive
integer from 1 to 65535. This ID does not have to match the ID on
any other device; it is for internal administrative use only. You can
use a maximum of two processes.
Step 2
ignore lsa mospf
Example:
hostname(config-rtr)# ignore lsa mospf
Suppresses the sending of syslog messages when the router
receives unsupported LSA Type 6 MOSPF packets.

Table of Contents

Other manuals for Cisco ASA Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA Series and is the answer not in the manual?

Cisco ASA Series Specifications

General IconGeneral
ModelASA 5505
InterfacesVaries by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High AvailabilityActive/Standby or Active/Active (varies by model)
Power SupplyVaries by model
Form FactorVaries by model
Operating SystemCisco ASA Software
IPsec VPNSupported
SSL VPNSupported
IPS ThroughputVaries by model

Related product manuals