Cisco ASA Series User Manual

CHAPTER
1-1
Cisco ASA Series CLI Configuration Guide
1
Adding a Standard Access Control List
This chapter describes how to configure a standard access list and includes the following sections:
• Information About Standard Access Lists, page 1-1
• Licensing Requirements for Standard Access Lists, page 1-1
• Guidelines and Limitations, page 1-1
• Default Settings, page 1-2
• Adding Standard Access Lists, page 1-3
• What to Do Next, page 1-4
• Monitoring Access Lists, page 1-4
• Configuration Examples for Standard Access Lists, page 1-4
• Feature History for Standard Access Lists, page 1-5
Information About Standard Access Lists
Standard access lists identify the destination IP addresses of OSPF routes and can be used in a route map
for OSPF redistribution. Standard access lists cannot be applied to interfaces to control traffic.
Licensing Requirements for Standard Access Lists
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature:
• Context Mode Guidelines, page 1-2
• Firewall Mode Guidelines, page 1-2
Model License Requirement
All models Base License.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model