Cisco ASA Series User Manual

1-4
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring AnyConnect Host Scan
Installing and Enabling Host Scan on the ASA
Enabling or Disabling a Host Scan
These commands enable or disable an installed Host Scan image using the command line interface of
the ASA.
Prerequisites
Log on to the ASA and enter global configuration mode. In global configuration mode, the ASA displays
this prompt: hostname(config)#
Detailed Steps for Enabling Host Scan
Detailed Steps for Disabling Host Scan
Viewing the Host Scan Version Enabled on the ASA
Use this procedure to determine the enabled Host Scan version using ASA’s command line interface.
Prerequisites
Log on to the ASA and enter privileged exec mode. In privileged exec mode, the ASA displays this
prompt: hostname#
Command Purpose
Step 1
webvpn
Example:
hostname(config)# webvpn
Enter webvpn configuration mode.
Step 2
csd enable
Example:
hostname(config)# csd enable
Enables the standalone Host Scan image or the Host Scan image
in the AnyConnect Secure Mobility Client package if they have
not been uninstalled from your ASA. If neither of those types of
packages is installed and a CSD package is installed, this enables
the Host Scan function in the CSD package.
Command Purpose
Step 1
webvpn
Example:
hostname(config)# webvpn
Enter webvpn configuration mode.
Step 2
no csd enable
Example:
hostname(config)# no csd enable
Disables Host Scan for all installed Host Scan packages.
Note Before you uninstall the enabled Host Scan image, you
must first disable Host Scan using this command.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model