Cisco ASA Series User Manual

1-3
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Logging for Access Lists
Configuring Logging for Access Lists
Firewall Mode Guidelines
Supported only in routed and transparent firewall modes.
IPv6 Guidelines
Supports IPv6.
Additional Guidelines and Limitations
ACE logging generates syslog message 106023 for denied packets. A deny ACE must be present to log
denied packets.
Default Settings
Table 1-1 lists the default settings for extended access list parameters.
Configuring Access List Logging
This sections describes how to configure access list logging.
Note For complete access list command syntax, see the “Configuring Extended ACLs” section on page 1-4
and the “Using Webtype Access Lists” section on page 1-2.
Table 1-1 Default Extended Access List Parameters
Parameters Default
log When the log keyword is specified, the default
level for syslog message 106100 is 6
(informational), and the default interval is 300
seconds.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model