Cisco ASA Series User Manual

1-17
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring a Cluster of ASAs
Information About ASA Clustering
Rebalancing New TCP Connections Across the Cluster
If the load balancing capabilities of the upstream or downstream routers result in unbalanced flow
distribution, you can configure overloaded units to redirect new TCP flows to other units. No existing
flows will be moved to other units.
ASA Features and Clustering
• Unsupported Features, page 1-17
• Centralized Features, page 1-18
• Features Applied to Individual Units, page 1-18
• Dynamic Routing, page 1-19
• NAT, page 1-21
• Syslog and Netflow, page 1-22
• SNMP, page 1-22
• VPN, page 1-22
• FTP, page 1-23
• Cisco TrustSec, page 1-23
Unsupported Features
These features cannot be configured with clustering enabled, and the commands will be rejected.
• Unified Communications
• Remote access VPN (SSL VPN and IPsec VPN)
• The following application inspections:
– CTIQBE
– GTP
– H323, H225, and RAS
– IPsec passthrough
– MGCP
– MMP
– RTSP
– SIP
– SCCP (Skinny)
– WAAS
– WCCP
• Botnet Traffic Filter
• Auto Update Server
• DHCP client, server, relay, and proxy
• VPN load balancing

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model