Cisco ASA Series User Manual

1-13
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the Identity Firewall
Task Flow for Configuring the Identity Firewall
What to Do Next
Configure access rules for the Identity Firewall. See Configuring Identity-Based Security Policy,
page 1-18.
Configuring Identity Options
Perform this procedure to add or edit the Identity Firewall feature; select the Enable check box to enable
the feature. By default, the Identity Firewall feature is disabled.
Prerequisites
Before configuring the identify options for the Identity Firewall, you must you must meet the
prerequisites for the AD Agent and Microsoft Active Directory. See Prerequisites, page 1-8 the
requirements for the AD Agent and Microsoft Active Directory installation.
To configure the Identity Options for the Identity Firewall, perform the following steps:

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model