Cisco ASA Series User Manual

1-9
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Access Rules
Monitoring Access Rules
Monitoring Access Rules
To monitor network access, enter the following command:
Configuration Examples for Permitting or Denying Network
Access
This section includes typical configuration examples for permitting or denying network access.
The following example adds a network object for inside server 1, performs static NAT for the server, and
enables access to from the outside for inside server 1.
hostname(config)# object network inside-server1
hostname(config)# host 10.1.1.1
hostname(config)# nat (inside,outside) static 209.165.201.12
hostname(config)# access-list outside_access extended permit tcp any object inside-server1
eq www
hostname(config)# access-group outside_access in interface outside
The following example allows all hosts to communicate between the inside and hr networks but only
specific hosts to access the outside network:
hostname(config)# access-list ANY extended permit ip any any
hostname(config)# access-list OUT extended permit ip host 209.168.200.3 any
hostname(config)# access-list OUT extended permit ip host 209.168.200.4 any
hostname(config)# access-group ANY in interface inside
hostname(config)# access-group ANY in interface hr
hostname(config)# access-group OUT out interface outside
For example, the following sample access list allows common EtherTypes originating on the inside
interface:
hostname(config)# access-list ETHER ethertype permit ipx
hostname(config)# access-list ETHER ethertype permit mpls-unicast
hostname(config)# access-group ETHER in interface inside
The following example allows some EtherTypes through the ASA, but it denies all others:
hostname(config)# access-list ETHER ethertype permit 0x1234
hostname(config)# access-list ETHER ethertype permit mpls-unicast
hostname(config)# access-group ETHER in interface inside
hostname(config)# access-group ETHER in interface outside
The following example denies traffic with EtherType 0x1256 but allows all others on both interfaces:
hostname(config)# access-list nonIP ethertype deny 1256
hostname(config)# access-list nonIP ethertype permit any
hostname(config)# access-group ETHER in interface inside
hostname(config)# access-group ETHER in interface outside
The following example uses object groups to permit specific traffic on the inside interface:
Command Purpose
show running-config access-group
Displays the current access list bound to the
interfaces.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model