Cisco ASA Series

1-11
Cisco ASA Series CLI Configuration Guide
Chapter 1 Getting Started with Application Layer Protocol Inspection
Configuring Application Layer Protocol Inspection
ipv6 [map_name] If you added an IP Options inspection policy map according
to “(Optional) Configuring an IPv6 Inspection Policy Map”
section on page 11-68, identify the map name in this
command.
mgcp [map_name] If you added an MGCP inspection policy map according to
“Configuring an MGCP Inspection Policy Map for
Additional Inspection Control” section on page 1-13,
identify the map name in this command.
netbios [map_name] If you added a NetBIOS inspection policy map according to
“Configuring a NetBIOS Inspection Policy Map for
Additional Inspection Control” section on page 1-30,
identify the map name in this command.
pptp —
radius-accounting [map_name]The radius-accounting keyword is only available for a
management class map. See the “Creating a Layer 3/4 Class
Map for Management Traffic” section on page 1-15 for more
information about creating a management class map.
If you added a RADIUS accounting inspection policy map
according to “Configuring a RADIUS Inspection Policy
Map for Additional Inspection Control” section on page 1-9,
identify the map name in this command.
rsh —
rtsp [map_name] If you added a RTSP inspection policy map according to
“Configuring an RTSP Inspection Policy Map for Additional
Inspection Control” section on page 1-16, identify the map
name in this command.
scansafe [map_name] If you added a ScanSafe (Cloud Web Security) inspection
policy map according to “Configuring a Service Policy to
Send Traffic to Cloud Web Security” section on page 25-11,
identify the map name in this command.
sip [map_name] If you added a SIP inspection policy map according to
“Configuring a SIP Inspection Policy Map for Additional
Inspection Control” section on page 1-20, identify the map
name in this command.
skinny [map_name] If you added a Skinny inspection policy map according to
“Configuring a Skinny (SCCP) Inspection Policy Map for
Additional Inspection Control” section on page 1-26,
identify the map name in this command.
snmp [map_name] If you added an SNMP inspection policy map according to
“Configuring an SNMP Inspection Policy Map for
Additional Inspection Control” section on page 1-10,
identify the map name in this command.
sqlnet —
Table 1-2 Protocol Keywords
Keywords Notes