Cisco ASA Series User Manual

1-88
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Connection Profiles, Group Policies, and Users
Supporting a Zone Labs Integrity Server
To specify the upper limit of the HTTP/HTTPS traffic, per transaction, to ignore, use the
keep-alive-ignore command in group-policy attributes webvpn configuration mode:
hostname(config-group-webvpn)# keep-alive-ignore size
hostname(config-group-webvpn)#
The no form of the command removes this specification from the configuration:
hostname(config-group-webvpn)# no keep-alive-ignore
hostname(config-group-webvpn)#
The following example sets the maximum size of objects to ignore as 5 KB:
hostname(config-group-webvpn)# keep-alive-ignore 5
hostname(config-group-webvpn)#
Specifying HTTP Compression
Enable compression of http data over a clientless SSL VPN session for a specific group or user by
entering the http-comp command in the group policy webvpn mode.
hostname(config-group-webvpn)# http-comp {gzip | none}
hostname(config-group-webvpn)#
To remove the command from the configuration and cause the value to be inherited, use the no form of
the command:
hostname(config-group-webvpn)# no http-comp {gzip | none}
hostname(config-group-webvpn)#
The syntax of this command is as follows:
• gzip—Specifies compression is enabled for the group or user. This is the default value.
• none—Specifies compression is disabled for the group or user.
For clientless SSL VPN sessions, the compression command configured from global configuration
mode overrides the http-comp command configured in group policy and username webvpn modes.
In the following example, compression is disabled for the group-policy sales:
hostname(config)# group-policy sales attributes
hostname(config-group-policy)# webvpn
hostname(config-group-webvpn)# http-comp none
hostname(config-group-webvpn)#
Specifying the SSO Server
Single sign-on support, available only for clientless SSL VPN sessions, lets users access different secure
services on different servers without reentering a username and password more than once. The
sso-server value command, when entered in group-policy-webvpn mode, lets you assign an SSO server
to a group policy.
To assign an SSO server to a group policy, use the sso-server value command in group-policy-webvpn
configuration mode. This command requires that your configuration include CA SiteMinder command.
hostname(config-group-webvpn)# sso-server value server_name
hostname(config-group-webvpn)#
To remove the assignment and use the default policy, use the no form of this command. To prevent
inheriting the default policy, use the sso-server none command.
hostname(config-group-webvpn)# sso-server {value server_name | none}
hostname(config-group-webvpn)# [no] sso-server value server_name

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model