Cisco ASA Series User Manual

1-91
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Connection Profiles, Group Policies, and Users
Configuring User Attributes
Configuring Inheritance
You can let users inherit from the group policy the values of attributes that you have not configured at
the username level. To specify the name of the group policy from which this user inherits attributes, enter
the vpn-group-policy command. By default, VPN users have no group-policy association:
hostname(config-username)# vpn-group-policy group-policy-name
hostname(config-username)# no vpn-group-policy group-policy-name
For an attribute that is available in username mode, you can override the value of an attribute in a group
policy for a particular user by configuring it in username mode.
The following example shows how to configure a user named anyuser to use attributes from the group
policy named FirstGroup:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-group-policy FirstGroup
hostname(config-username)#
Configuring Access Hours
Associate the hours that this user is allowed to access the system by specifying the name of a configured
time-range policy:
To remove the attribute from the running configuration, enter the no form of this command. This option
allows inheritance of a time-range value from another group policy. To prevent inheriting a value, enter
the vpn-access-hours none command. The default is unrestricted access.
hostname(config-username)# vpn-access-hours value {time-range | none}
hostname(config-username)# vpn-access-hours value none
hostname(config)#
The following example shows how to associate the user named anyuser with a time-range policy called
824:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-access-hours 824
hostname(config-username)#
Configuring Maximum Simultaneous Logins
Specify the maximum number of simultaneous logins allowed for this user. The range is 0 through
2147483647. The default is 3 simultaneous logins. To remove the attribute from the running
configuration, enter the no form of this command. Enter 0 to disable login and prevent user access.
hostname(config-username)# vpn-simultaneous-logins integer
hostname(config-username)# no vpn-simultaneous-logins
hostname(config-username)# vpn-session-timeout alert-interval none
Note While the maximum limit for the number of simultaneous logins is very large, allowing several could
compromise security and affect performance.
The following example shows how to allow a maximum of 4 simultaneous logins for the user named
anyuser:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-simultaneous-logins 4
hostname(config-username)#

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model