Cisco ASA Series User Manual

1-17
Cisco ASA Series CLI Configuration Guide
Appendix 1 Configuring an External Server for Authorization and Authentication
Configuring an External LDAP Server
Figure 1-3 LDAP User Configuration
Step 3
Create an LDAP attribute map on the ASA.
The following example creates the map Banner and maps the AD/LDAP attribute
physicalDeliveryOfficeName to the Cisco attribute Banner1:
hostname(config)# ldap attribute-map Banner
hostname(config-ldap-attribute-map)# map-name physicalDeliveryOfficeName Banner1
Step 4 Associate the LDAP attribute map to the AAA server.
The following example enters the aaa server host configuration mode for the host 10.1.1.2 in the AAA
server group MS_LDAP, and associates the attribute map Banner that you created in Step 3:
hostname(config)# aaa-server MS_LDAP host 10.1.1.2
hostname(config-aaa-server-host)# ldap-attribute-map Banner
Step 5 Test the banner enforcement.
The following example shows a clientless SSL connection and the banner enforced through the attribute
map after the user authenticates (see Figure 1-4).

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model