EasyManuals Logo

Cisco ASA Series User Manual

Cisco ASA Series
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #470 background imageLoading...
Page #470 background image
1-14
Cisco ASA Series CLI Configuration Guide
Chapter 1 Completing Interface Configuration (Routed Mode)
Completing Interface Configuration in Routed Mode
Note Configuring the global address automatically configures the link-local address, so you do not need to
configure it separately.
Restrictions
The ASA does not support IPv6 anycast addresses.
Prerequisites
Set up your interfaces depending on your model:
ASA 5510 and higher—Chapter 1, “Starting Interface Configuration (ASA 5510 and Higher).
ASA 5505—Chapter 1, “Starting Interface Configuration (ASA 5505).
ASASM—Chapter 1, “Configuring the Switch for Use with the ASA Services Module.
In multiple context mode, you can only configure context interfaces that you already assigned to the
context in the system configuration according to the “Configuring Multiple Contexts” section on
page 1-15.
In multiple context mode, complete this procedure in the context execution space. To change from
the system to a context configuration, enter the changeto context name command.
Detailed Steps
Command Purpose
Step 1
For the ASA 5510 and higher:
interface {{redundant number |
port-channel number |
physical_interface}[.subinterface] |
mapped_name}
For the ASA 5505 or ASASM:
hostname(config)# interface {vlan number |
mapped_name}
Example:
hostname(config)# interface
gigabithethernet 0/0
If you are not already in interface configuration mode, enters
interface configuration mode.
The redundant number argument is the redundant interface ID,
such as redundant 1.
The port-channel number argument is the EtherChannel interface
ID, such as port-channel 1.
See the “Enabling the Physical Interface and Configuring
Ethernet Parameters” section for a description of the physical
interface ID.
Append the subinterface ID to the physical or redundant interface
ID separated by a period (.).
In multiple context mode, enter the mapped_name if one was
assigned using the allocate-interface command.
Step 2
Do one of the following:

Table of Contents

Other manuals for Cisco ASA Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA Series and is the answer not in the manual?

Cisco ASA Series Specifications

General IconGeneral
ModelASA 5505
InterfacesVaries by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High AvailabilityActive/Standby or Active/Active (varies by model)
Power SupplyVaries by model
Form FactorVaries by model
Operating SystemCisco ASA Software
IPsec VPNSupported
SSL VPNSupported
IPS ThroughputVaries by model

Related product manuals