Cisco ASA Series User Manual

1-19
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring AAA Servers and the Local Database
Configuring AAA
To set up VPN user authorization using LDAP, perform the following steps.
Detailed Steps
Examples
While there are other authorization-related commands and options available for specific requirements,
the following example shows commands for enabling user authorization with LDAP. The example then
creates an IPsec remote access tunnel group named remote-1, and assigns that new tunnel group to the
previously created ldap_dir_1 AAA server group for authorization:
hostname(config)# tunnel-group remote-1 type ipsec-ra
hostname(config)# tunnel-group remote-1 general-attributes
hostname(config-general)# authorization-server-group ldap_dir_1
hostname(config-general)#
After you complete this configuration work, you can then configure additional LDAP authorization
parameters such as a directory password, a starting point for searching a directory, and the scope of a
directory search by entering the following commands:
hostname(config)# aaa-server ldap_dir_1 protocol ldap
hostname(config-aaa-server-group)# aaa-server ldap_dir_1 host 10.1.1.4
hostname(config-aaa-server-host)# ldap-login-dn obscurepassword
hostname(config-aaa-server-host)# ldap-base-dn starthere
hostname(config-aaa-server-host)# ldap-scope subtree
hostname(config-aaa-server-host)#
Command Purpose
Step 1
aaa-server server_group protocol {kerberos | ldap |
nt | radius | sdi | tacacs+}
Example:
hostname(config)# aaa-server servergroup1 protocol
ldap
hostname(config-aaa-server-group)
Creates a AAA server group.
Step 2
tunnel-group groupname
Example:
hostname(config)# tunnel-group remotegrp
Creates an IPsec remote access tunnel group named
remotegrp.
Step 3
tunnel-group groupname general-attributes
Example:
hostname(config)# tunnel-group remotegrp
general-attributes
Associates the server group and the tunnel group.
Step 4
authorization-server-group group-tag
Example:
hostname(config-general)# authorization-server-group
ldap_dir_1
Assigns a new tunnel group to a previously created
AAA server group for authorization.

Cisco ASA Series Specifications

General

Model	ASA 5505
Interfaces	Varies by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High Availability	Active/Standby or Active/Active (varies by model)
Power Supply	Varies by model
Form Factor	Varies by model
Operating System	Cisco ASA Software
IPsec VPN	Supported
SSL VPN	Supported
IPS Throughput	Varies by model