Distributed Architecture of MUR â–€
Cisco ASR 5000 Series Product Overview â–„
Distributed Architecture of MUR
MUR supports the distributed model to allow the deployment which enables network wide view or work load balancing.
Newly introduced component, Remote Data Processor (RDP), plays the role of pre-processing the input files from
gateways. One or more RDPs, installed separately on remote machines can be registered to a master MUR and one RDP
can process files from one or more gateways.
RDP periodically sends the intermediate data to registered master MUR. The role of MUR in such deployments is
mostly for report generation, report viewing, RDP management and optionally data processing.
Important: RDP installation and registration is required only for network wide deployments. For standalone
installation no RDP is required. For information on how to install the RDP, refer to the Managing MUR Installation
chapter of this guide.
Important: RDP and MUR must be installed, upgraded, and uninstalled separately.
Important: Before registering RDP with the master MUR, ensure that the RDP is installed and running.
Important: The RDP management like configuration and removal is possible from MUR GUI only. For
information on managing the RDPs, refer to the MUR Online Help.
Important: For Bulkstat, there is no support for distributed model and all the bulkstat input files will be parsed
by master MUR only.
The following figure illustrates the distributed architecture of MUR.
To Next Page
Loading...
Need help?
General
