3-41
Catalyst 2950 Desktop Switch Hardware Installation Guide
78-11157-05
Chapter 3 Installation
Connecting to an LRE Port
Connecting to a Patch Panel or POTS Splitter
To connect the LRE port to a patch panel or POTS splitter, follow these steps:
Step 1 Connect one end of a cable connected to the wiring trunk to the RJ-21 connector
(the LRE port) on the switch. (See Figure 3-36 and Figure 3-37.)
Step 2 Referring to Figure 3-36 and Figure 3-37, secure the cable to the switch:
• For a 90-degree connector, see the top of Figure 3-36 and Figure 3-37.
• For a 12-degree connector, see the bottom of Figure 3-36 and Figure 3-37.
Note The cable tie is not included with the connector and cable assembly.
Step 3 Connect the other end of the cable to the patch panel or POTS splitter.
To Next Page
Loading...
