Cisco Catalyst 2950 Hardware Installation Guide

2-31
Catalyst 2950 Desktop Switch Hardware Installation Guide
78-11157-05
Chapter 2 Overview
Rear-Panel Description
The RPS is a 300W redundant power system that can support six external network
devices and provides DC power to one failed device at a time. It automatically
senses when the internal power supply of a connected device fails and provides
power to that device, preventing loss of network traffic.
For more information, refer to the Cisco RPS 300 documentation.
Cisco RPS 675
The Cisco RPS 675 has two output levels: –48V and 12V with a total maximum
output power of 675W. Use the supplied RPS connector cable to connect the RPS
to the switch.
Warning Attach only the Cisco RPS 675 (model PWR675-AC-RPS-N1=) to the RPS
receptacle.
The RPS is a 675W redundant power system that can support six external network
devices and provides DC power to one failed device at a time. It automatically
senses when the internal power supply of a connected device fails and provides
power to that device, preventing loss of network traffic.
For more information, refer to the Cisco RPS 675 documentation.
Console Port
You can connect a switch to a PC through the console port and the supplied
RJ-45-to-DB-9 adapter cable. If you want to connect a switch to a terminal, you
need to provide an RJ-45-to-DB-25 female DTE adapter. You can order a kit (part
number ACS-DSBUASYN=) with that adapter from Cisco. For console-port and
adapter-pinout information, see the “Cable and Adapter Specifications” section
on page B-8.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz